How To Use Foam Pump Bottle

How To Use Foam Pump Bottle

How to use a foam bottle, here are our suggestions and how to do it

Choose the right liquid soap

The foam pump is designed to work with water-like substances, so the selected liquid must have enough surfactant, the selected liquid needs to be water-based, and be able to foam under air.

When your product is sufficiently diluted, most of the resulting liquid can be used in a foam pump bottle. But some products with added thickeners require a lot of water to dilute them to the point where the foam pump is usable, but this can compromise the effectiveness and lather of the original foam.

Handmade liquid soaps usually work best in foam pump bottles because they don't contain boosters and thickeners, but don't use melted soap in place of actual liquid soap. Because this is very prone to clumping or gelling, which can lead to clogging the mechanism inside the foam pump.

degree of dilution

For a very thick lather, normal liquid soap should be diluted 3-6 times. The ratio of liquid and water is 1:3 at the beginning, and the amount of water can be added according to the foam effect you like.

Why does adding other additives not work in the foam pump bottle?

Because the inside of the foam pump works through the mesh screen, the mixing action of the foam and the air produces the foam. The holes of the mesh screen are very small and are very easy to be blocked. We recommend not to add any large solid particles (the particles should be smaller than 79 microns as much as possible). When a large number of solid particles gather together, they will not pass through the mesh because they are too large. screen. Large solid particles contain mica, pigments and any type of glitter etc. If you need a colored liquid foam, then use a cosmetic approved fuel. They act like food coloring and try to avoid clogging the screen with solid particles.

How to use the foam pump bottle?

as a recyclable product. When we designed and produced the pump head and bottle, we had tested it on a variety of products, at least 10,000 times. At the time, the actual situation was more than that. If the pump head can be relatively protected during use, it will be used more times.

The foam pump head is not suitable for use in the case of running water, especially in the bathing process, and try to avoid rinsing the bottle under the condition of running water as little as possible, otherwise the water flow is very easy to penetrate the air intake chamber, which will destroy the work of the bottle and the pump head.

When filling liquid, the water should not be too full, and the amount of water should be lower than the top of the bottle. If the top is exceeded, the liquid will seep into the air chamber. If you find that you can't pump out during use, it may be because the pump is not used frequently, causing the liquid to dry out and form a film on the screen, making it difficult to use.

In order to make the pump head work better, we will add a small amount of lubricant on it to ensure smooth operation. But because we consider safety and environmental protection issues, we have upgraded the original products. Foam pump with external spring, the liquid of this foam pump will not pass through the spring. In the original old foam pump, if the foam pump is not used for a long time, the spring in the pump head will rust, causing the liquid to be stained with rust liquid, thus hurt the body. Our external design will protect the product, and if the product is no longer needed, it will be easier to recycle the product.

If you interest with us product, pls contact us and get more information.